How to Install Motorcycle Pro Ball Mount + Charging Head Kit

Quick Answer

Mount the Pro Ball base to your handlebar, attach the vibration dampener, then connect the 15W charging head and secure your phone. Each step requires specific torque and alignment to avoid damage.

Installation Steps

1. 1. Attach the Pro Ball Mount Base: Loosen the handlebar clamp screws, slide the base onto your handlebar at your desired position, then tighten the screws evenly to the manufacturer's torque specification (usually 4-5 Nm). Check that the ball head faces upward and is clear of any brake lines or throttle cables. Common mistake: over-tightening can crack the clamp. Use a torque wrench if available.
2. 2. Install the Vibration Dampener: Slide the vibration dampener onto the ball mount's ball head. Press firmly until it clicks into place. The dampener should rotate freely but not wobble. If it feels loose, remove and re-seat it. Check that the dampener is seated fully; a half-seated dampener can cause your phone to vibrate loose.
3. 3. Mount the 15W Charging Head: Align the charging head's rear socket with the dampener's arm and push until it locks. Connect the charging cable to your motorcycle's power source (typically a USB-C or barrel connector). Route the cable away from moving parts and heat sources. Common mistake: routing the cable too tightly can pinch it when you steer. Leave a little slack.
4. 4. Position Your Phone and Tighten: Place your phone onto the charging head's cradle. The charging coil in your phone should align with the center of the charging pad. Tighten the side grips until the phone is secure but not compressed. Test by gently shaking the mount. If your phone does not charge, adjust its position slightly. The coil alignment is critical for wireless charging.

Product Facts

• Motorcycle Pro Ball Mount + 15W Charging Head w/ Vibration Dampener Kit: Bundle pricing only available when adding bundle to your cart. Bundle will not apply if you add products individually. Make sure to add the bundle as a single item to your cart to get the 10% savings. Adding the mount and charger separately will not apply the discount.