iPhone 13 Pro Max Tempered Glass 2 Pack: Install and Replace
By Protective Cases & Accessories for Apple iPhone and Samsung | Published: 2026-11-05
Category: Avaliações de Produtos
A step-by-step guide to installing the iPhone 13 Pro Max Tempered Glass 2 Pack, fixing bubbles, and knowing when to replace each protector.
Quick answer
Install the first protector in a steamy bathroom to reduce dust, align it carefully, and smooth bubbles outward. Replace it when scratches, chips, or lifting edges appear—your second pack is ready.
Why the two-pack changes your approach
With two protectors, you can treat the first as a learning install. If dust or a stubborn bubble ruins it, you still have a backup—so don’t panic-peel a good install just to fix a tiny flaw.
The 0.33mm glass is thin enough to preserve touch response and 3D Touch, but that also means edges can chip if you routinely drop the phone face-down. A spare lets you swap immediately instead of living with a cracked edge.
When replacement is the right call
Replace when you see deep scratches that catch a fingernail, chips along the edge, or lifting that traps lint. Hairline scratches that disappear when the screen is off are cosmetic and can wait.
If a bubble won’t smooth out after 48 hours, it usually means trapped dust or a bent protector—replace it rather than pressing harder, which can crack the glass.
Install and replace steps
- Prepare a dust-free workspace: Run a hot shower for a few minutes to add humidity, which settles dust. Work on a clean, flat surface with good light and wash your hands. Avoid installing in a dry, breezy room—airborne dust is the main cause of bubbles.
- Clean the screen thoroughly: Use the supplied alcohol wipe, then dry with a lint-free cloth. Inspect at an angle and lift any remaining specks with a dust sticker. Don’t skip the angled inspection; a single speck under the glass creates a permanent bubble.
- Align and drop the protector: Peel the backing and hold the glass by the edges. Line up the cutouts for the speaker and camera, then let it drop gently into place. Check alignment before pressing—once the adhesive touches, repositioning is difficult.
- Smooth bubbles outward: Press from the center outward with a finger or card wrapped in cloth. Work small bubbles toward the nearest edge. If a bubble won’t move, lift the nearest corner slightly with a card and re-lay it—don’t force it.
- Wait 24–48 hours before judging: Small bubbles often disappear as the adhesive settles. Avoid pressing hard or using the phone in a hot car during this time. If a bubble persists after two days, it’s likely dust—use your second protector.
- Replace at the first sign of damage: Swap the protector when you see chips, deep scratches, or lifting edges. Clean the screen fully before applying the new one. Keep the second protector stored flat and dust-free so it’s ready when you need it.
Product facts
- iPhone 13 Pro Max Tempered Glass Screen Protector (2 Pack): 9H hardness tempered glass manufactured in Japan. The hard surface resists everyday scratches, so you can use the phone normally without worrying about keys or coins in a pocket.
iPhone 13 Pro Max Tempered Glass Screen Protector (2 Pack) - iPhone 13 Pro Max Tempered Glass Screen Protector (2 Pack): Ultra-thin 0.33mm glass with 3D touch compatibility. The thin profile keeps touch and 3D Touch responsive, so you don’t sacrifice feel for protection.
